Form Tube 420 is high-strength formable precision tube. It has 15% higher elongation values and very narrow tolerances compared with competing products. Available in circular, rectangular, square and special shapes, it comes with different coating and surface options including cold rolled, galvanized, galvannealed and galfan. Customized shapes and other tailoring options are available upon request. Typically uses include light engineering, where formability, uniform quality, different surface options and usability are important.
SSAB Form Tube 420 is available in circular, square and rectangular shapes.
Other shapes, sizes and lengths are available upon request.
1) Elongation A-value according to +CR2, 12%.
1) Elongation A-value according to +CR2, 12%.
1) Elongation A-value according to +CR2, 12%.
Mechanical properties meet or exceed the requirements of EN 10305 (+CR2).
Chemical composition meets or exceeds the requirements of EN 10305.
If other chemical elements such as Ti, Nb or V are used, the content of these elements are reported in the inspection document.
1) SSAB Form Tube H grade is suitable for high quality hot-dip galvanizing (Si < 0.03%, Si +2.5P < 0.06%)
2) Low level of impurities ensure excellent formability and weldability
3) This requirement is not applicable provided the steel contains a sufficient amount of other nitrogen binding elements, such as Ti, Nb or V.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
Surface is slightly oiled to protect it from corrosion during transportation and short-term storage. By request, tubes can be delivered dry, however in that case SSAB will not be responsible for any possible rust.
Galfan coating ZA255 by SSAB has been granted a C3 15 (years) certification by RISE, Research Institute of Sweden AB.
1) Theoretical guidance values for coating thickness per surface.
2) Minimum coating mass - g/m2 refers the total weight of coatings on both sides of a 1 m2 plate.