How to cut > How to postheat after thermal cutting

Postheating soaking time recommendations

To achieve effective postheating, the entire cross-section of the plate must reach the target temperature, generally for all steel grades. A certain amount of time is required for the heat to spread throughout the plate. It's important to note that the surface should be maintained at the target temperature consistently during the soaking period. The graphs provided can be used to determine the required soaking time.

For example, when preheating a 100mm plate to 175°C from both sides, when a surface temperature of 175°C is reached, this temperature should be maintained for 11 minutes to ensure the core of the plate has the same temperature.

Required soaking time when heat is applied from both sides, for example heating in a furnace

Required soaking time when the heat is supplied from one side only, for example, heating with propane torches or heating with electrical mats

Contact Technical support


The information in this report is only applicable to SSAB’s products and should not be applied to any other products than original SSAB products. 


This report provides general results and recommendations for SSAB steel products. This report is subject to SSAB’s Terms of Use. It shall be the user's responsibility to verify that the information contained herein is correct and is suitable to be used for the particular purpose and application of the user. The report is intended to be used by professional users only who possess adequate expertise, qualification and knowledge for the safe and correct use of the results and recommendations in this report. This report is provided “as is”. The use of the report is at user’s own discretion and risk and that users will be solely responsible for any use of this report. SSAB disclaims any liability for the content or potential errors of this report, including but not limited to warranties and condition of merchantability or fitness for a particular purpose or suitability for individual applications. SSAB shall not be liable for any kind of direct or indirect damages and/or costs related to or arising therefrom, whether special, incidental, consequential or directly or indirectly related to the use of, or the inability to use, the report or the content, information or results included therein.